Huawei Tecal RH5485 Problem Determination And Service Manual page 153

Hide thumbs Also See for Tecal RH5485:

Table of Contents

Tecal RH5485 Server

Problem Determination and Service Guide

Removing a hot-swap hard disk drive

Important: Before you remove a hot-swap hard disk drive from the server, take the

following precautions to save data, firmware, and configuration data:



To remove the hot-swap hard disk drive, complete the following steps.

Step 1 Read the safety information and "Installation guidelines".

Step 2 Make sure you save the data on your drive, especially if it is part of a RAID array, before you

remove it from the server.

Step 3 Push the latch on the handle to the left, then open the drive handle and pull the hard disk

drive assembly out of the server.

Step 4 If you are instructed to return the hot-swap hard disk drive, follow all packaging instructions,

and use any packaging materials for shipping that are supplied to you.

----End

Replacing a hot-swap hard disk drive

To install the replacement hot-swap hard disk drive, complete the following steps:

Step 1 Touch the static-protective package that contains the hard disk drive to any unpainted surface

on the outside of the server; then, remove the hard disk drive from the package.

Step 2 Make sure that the tray handle is open; then, slide the hard disk drive into the hot-swap bay.

Issue 02 (2011-05-25)

Before you make changes to disk drives, disk drive controllers (including controllers that

are integrated on the system board), disk drive backplanes, or disk drive cables, back up

all important data that is stored on hard disks.

Before you remove any component of a RAID array, back up all RAID configuration

information.

Huawei Proprietary and Confidential

5 Removing and replacing components

5-23

Table of Contents