Huawei Tecal RH5485 Problem Determination And Service Manual page 170

Hide thumbs Also See for Tecal RH5485:

Table of Contents

5 Removing and replacing components

Step 10 Press on the release latches on the front side of the USB mounting bracket and push the

mounting bracket into the server.

Step 11 Pull the USB assembly through the opening and remove it from the server.

Step 12 If you are instructed to return the front USB assembly, follow all packaging instructions, and

use any packaging materials for shipping that are supplied to you.

----End

Replacing the front USB assembly

To install the replacement front USB assembly, complete the following steps:

Step 1 Insert the USB assembly into the opening from inside the server and push it in until it clicks

into place.

Step 2 Route the USB assembly cable under the hard disk drive backplane to the outside of the

RAID PCI Express connector.

Step 3 Install the memory-card cage assembly (see "Replacing the memory-card cage").

Step 4 Connect the SAS cables to the RAID card controller.

Step 5 Install the RAID card controller ("Replacing the RAID adapter carrier and the RAID adapter

assembly").

Step 6 Install the middle fan (see "Replacing the middle hot-swap fan").

Step 7 Install the memory cards and memory card fillers (see "Replacing the memory card").

Step 8 Install the top cover bracket (see "Replacing the top-cover bracket").

Step 9 Install the top cover (see "Replacing the top cover") and the front bezel (see "Replacing the

front bezel").

Step 10 Connect the cables and power cords (see "Connecting the cables" for cabling instructions).

Step 11 Turn on all attached devices and the server.

----End

Removing the I/O-board shuttle

To remove the rear I/O-board shuttle, complete the following steps.

5-40

Huawei Proprietary and Confidential

Tecal RH5485 Server

Problem Determination and Service Guide

Issue 02 (2011-05-25)

Table of Contents