Huawei Tecal RH5485 Problem Determination And Service Manual page 46

3 Diagnostics
3xx0007
(xx can be
00 - 19)
3038003
3048005
3048006
305000A
3058001
3-28
Firmware fault
system halted
Firmware corrupted
Booted secondary (backup)
server firmware image
Booted secondary (backup)
server firmware
because of ABR
RTC date/time is incorrect
System configuration invalid 1. Run the Setup utility, and select Save
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Problem Determination and Service Guide
shuttle
detected, 1. Recover the server firmware to the latest
level.
2. Undo any recent configuration changes, or
clear CMOS memory to restore the settings to
the default values.
3. Remove any recently installed hardware.
1. Run the Setup utility, select Load Default
Settings, and save the settings to recover the
server firmware.
2. (Trained service technician only) Replace
the I/O-board shuttle.
Information only. The backup switch was used
to boot the secondary bank.
1. Run the Setup utility, select Load Default
image Settings, and save the settings to recover the
primary server firmware settings.
2. Turn off the server and remove it from the
power source.
3. Reconnect the server to the power source,
and
then turn on the server.
1. Adjust the date and time settings in the Setup
utility, and then restart the server.
2. Reseat the battery.
3. Replace the following components one at a
time,
in the order shown, restarting the server each
time:
a. Battery
b. (Trained service technician only) I/O-board
shuttle
Settings.
2. Run the Setup utility, select Load Default
Settings, and save the settings.
3. Reseat the following components one at a
time in the order shown, restarting the server
each time:
a. Battery
b. Failing device (if the device is a FRU, it must
be reseated by a trained service technician
only)
4. Replace the following components one at a
Tecal RH5485 Server
Issue 02 (2011-05-25)