Huawei Tecal RH5485 Problem Determination And Service Manual page 150

5 Removing and replacing components
Step 2 Thread the operator information panel cable into the operator information panel bay and
insert the assembly into the server from the front.
Step 3 Connect the cable to the microprocessor board.
Step 4 Install the memory cards or fillers in slots 5, 6, 7, and 8 (see "Replacing the memory card").
Step 5 Install the front bezel and the top cover (see "Replacing the front bezel" and "Replacing the
top cover").
Step 6 Connect the cables and power cords (see "Connecting the cables" for cabling instructions).
Step 7 Turn on all attached devices and the server and check the server for normal operation.
----End
Removing the front hot-swap fans
To remove a front hot-swap fan, complete the following steps:
Step 1 Read the safety information and "Installation guidelines".
Step 2 Remove the front bezel.
Step 3 Open the fan-release handle by pushing the orange release latch down.
5-20 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Tecal RH5485 Server
Problem Determination and Service Guide
Issue 02 (2011-05-25)