Table of Contents
Advertisement
3 Diagnostics
Message
Array in system %1 is in
critical con- dition.
（%1 =
CIM_ComputerSystem.
ElementName）
Array in system %1 has
failed.
（%1 = CIM_ComputerSystem
.ElementName）
Failure predicted on Drive
1 Status for array SN#
ZZZZZZP.
Memory Errors
NOTE
Memory Expansion Unit 1 was
detected as absent.
Memory Expansion Unit 1
detected as present.
Uncorrectable error detected
for all DIMMs
on
Subsystem
System
Memory.
3-82
Severity Description
Error
An array is in Critical state.
(Sensor = Drive n Status)
(n = hard disk drive number)
Error
An array is in Failed state.
(Sensor = Drive n Status)
(n = hard disk drive number)
Warning
A drive is about to fail.
A DIMM error message indicates the DIMM, but not the memory card, on which the error has
occurred.
DIMMs 1 - 8 are on memory card 1, DIMMs 9 - 16 are on memory card 2, and so on.
The memory expansion unit was
Info
detected as absent when it was
expected to be present.
Info
The memory expansion unit was
detected as present when it was
expected to be absent.
Error
A memory uncorrectable error
has occurred.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Tecal RH5485 Server
Problem Determination and Service Guide
Action
Replace the hard disk drive that
is indicated by a lit status LED.
Replace the hard disk drive that
is indicated by a lit status LED.
Replace the hard disk drive that
is indicated by a lit status LED.
Check the QPI cable
connections, then reboot the
server to see if it recovers.
Check the QPI cable
connections, then reboot the
server to see if it recovers.
1.
If the server failed the
POST memory test, reseat the
DIMMs.
2.
Replace any DIMM that is
indicated by a lit error LED.
Note: You do not have to replace
DIMMs by pairs.
3.
Run the Setup utility to
enable all the DIMMs.
4.
Run the memory test. (This
test might take up to 30 minutes
to run.)
Issue 02 (2011-05-25)
Advertisement
Table of Contents
