Cabling The G600 Media Gateways; Cabling 2 Media Gateways - Avaya S8700 Installing Manual

82 Installing the Avaya™ S8700 Media Server with Avaya™ G600 Media Gateway

Cabling the G600 Media Gateways

After mounting the G600 Media Gateways in the rack, you must connect the TDM/LAN cables
between them. You must also connect CAT5 cables to the appropriate slots on the back of the
media gateways.
NOTE:
TDM/LAN bus terminators are factory installed on a single Avaya G600 Media Gateway.
See
Media gateway A TDM/LAN bus terminators
Figure notes
1
You can mount and cable up to 4 media gateways in a rack. The media gateway on the bottom is
referred to as media gateway A. The others are referred to as media gateways B, C, and D from
bottom to top.
When cabling the media gateways together, refer to the TDM Cable Installation Diagram
included with the shipment.

Cabling 2 Media Gateways

Remove the bottom panel from media gateway B.
1
2 If not already removed, remove the fan assemblies from media gateways A and B.
''Media gateway A TDM/LAN bus terminators'' on page 82
A
TDM/LAN bus terminators (at each end
of the TDM/LAN bus)
1
May 2003
1
cadptdm1 KLC 102600