Install The Hospitality Integrated Voice Services Card; Cabling - Avaya Communication Server 1000M Single Group Manual

Hospitality integrated voice services fundamentals
Hide thumbs Also See for Communication Server 1000M Single Group:
Table of Contents

Advertisement

Installation and configuration
6. Fasten the I/O panel to the module using the retaining screws that was removed

Install the Hospitality Integrated Voice Services card

Follow the steps in
the Hospitality Integrated Voice Services card.
Installing a Hospitality Integrated Voice Services card
1. Identify the IPE card slot selected for the Hospitality Integrated Voice Services
2. Make sure that the hard drive PC Card is in the lower PC Card slot on the faceplate,
3. Pull the top and bottom extractors away from the Hospitality Integrated Voice
4. Insert the Hospitality Integrated Voice Services card into the card guides and gently
5. Push the top and the bottom extractors firmly towards the faceplate to insert the
6. Observe the red LED at the top of the faceplate (the card LED).

Cabling

The Hospitality Integrated Voice Services card is connected to the following through the
Ethernet adapter:
• LAN (refer to
• maintenance terminal (refer to
LAN exists
• BGD terminal (refer to
Before these connections are made, attach the NTBK48AA cable to the DB-9 connector of the
Ethernet adapter. See
page 51.
50
Hospitality Integrated Voice Services Fundamentals
See
Figure 7: I/O connector bracket connection
earlier. Replace the module's cover plate.
Installing a Hospitality Integrated Voice Services card
card.
and that it is firmly seated.
Services card faceplate.
push the card until the card makes contact with the backplane connector.
Hospitality Integrated Voice Services card into the faceplate connector and to lock
the card firmly in place.
The LED blinks three times after the self-test successfully finishes. The LED then
stays ON until the Hospitality Integrated Voice Services card is software-enabled.
Connecting the Ethernet adapter to the LAN
on page 52)
Connecting the BGD terminal
Figure 6: The Ethernet adapter and the NTBK48AA cable
Comments? infodev@avaya.com
Connecting Ethernet adapter to customer PC when no
on page 53.
on page 50 to install
on page 51)
on page 57)
on
March 2013

Advertisement

Table of Contents
loading

Table of Contents