Table of Contents
Advertisement
INTUITY Messaging Solutions Release 5 Migration Procedures
Cabling the INTUITY AUDIX System
30
6. Press the down arrow until the cursor highlights Continue.
7. Press ENTER.
The system removes the migration package and displays the
following messages:
Removal completed successfully
Press [Enter] to continue.
8. Press ENTER.
9. Press F6 (Cancel) to exit the Software Removal screen.
The system displays the INTUITY Main Menu.
Note:
Note:
The main menu displays the Migration option until you log off and
then back on.
10. Return to the Migration Checklist (page 2).
You must cable the INTUITY AUDIX system to the switch. The steps in
this procedure depend on the communication mode of the DEFINITY
AUDIX.
To cable the INTUITY AUDIX to the switch:
1. Do one of the following:
n
If the DEFINITY AUDIX was in CL mode, the BX.25
connection is required. Go to Using a BX.25 Connection
(page 31).
n
If the DEFINITY AUDIX system was in Display Set (DS)
mode, install the customer's hardware in the switch. Go to
See Chapter 2 in the INTUITY Messaging Solutions Release 5
Integration Using Digital Station Interface document located
on the INTUITY Messaging Solutions Release 5
Documentation for Technicians CD-ROM, 585-313-807.
Follow the steps in that chapter. Then go to Administering for
the Switch (page 32).
585-313-118 Issue 4
June 2002
Advertisement
Table of Contents
