Testing Port Network Equipment; Check Port Network Status For Each Media Gateway - Avaya S8700 Installing

Migrating to an Avaya™ S8700 Media Server with Avaya™ MCC1 or SCC1 Media Gateway

Testing port network equipment

These tests verify that the Time Division Multiplexing (TDM) cables, terminators, and the
Inter-Cabinet Cables (MCC1 Media Gateway) work. If a FAIL Result code is seen, check these
cables. If problems persist, refer to the maintenance book for your configuration
Check port network status for each media
gateway
The port network status may suggest problem areas. Tests described later provide more specific
diagnostic information.
1 Type status port-network number <1-64> and press
Verify the screen displays a Port Network Status screen similar to the one in
Port Network Status Screen for Cabinet 1—S8700
Verify these service states:
Field Service State
TDM Bus A in
TDM Bus B in
Tone/Clock in
PKT in
Sample Port Network Status Screen for Cabinet 1—S8700 Multi-Connect
status port-network 1
Major Minor Warning Carrier
PN Alarms Alarms Alarms
1 1 0
TDM Service Control
Bus State Channel
A in y
B in n
Service
PKT State
1
Command:
PORT NETWORK STATUS
PN Control
Locs Active Standby
195 01A up up
01B
Dedicated
Tones
n
y
Major Minor
Alarms Alarms
in n n
May 2003
Testing the Complete Configuration
.
Enter
Multi-Connect".
FIBER-
LINK Endpoints
1 B-PNC 01B02-03E04 standby
1 A-PNC 01A01-01E04 active
TONE/ Service System
CLOCK State Clock
01B in standby
01A in active
Bus Open Bus
Faults Leads
0 0
291
.
"Sample
Mode
System
Tones
standby
active