2. Position the toothed segment P201b −A− on the stud and undo the pan−head screws in several
stages and in diametrically opposite sequence, to avoid deforming the thrust plate.
top of page
Installing clutch
1. Fit drive plate with centring mandrel, special tools centring mandrel 9102 in the guide bearing
(needle bush).
2. Fit thrust plate. To do so, position the special tool toothed segment P201b −A− on the stud and
tighten the pan−head screws in several stages and in diametrically opposite sequence.
Tightening torque: 23 Nm (17 ftlb.)
3. Remove the special tool centring mandrel 9102 .
4. Remove the special tool toothed segment P201b .
5. Refit transmission ' 34 35 27 Removing and refitting the
transmission.
top of page
Tightening torques
Location
Pan−head screws thrust plate − ZMS
996420, 996421, 996450, 996451, 996620, 996621, 996650, 996651
Removing clutch
einordnung
Thread
Tightening torque Nm (ftlb.)
M8
23 (17)
683