•
Cover the chain space briefly when fitting so that parts do not fall into the crankcase.
32. Mount hexagon nut M10 x 1.25 and washer A10.5 on stud, with rounded side pointing towards the
hexagon nut.
33. Mount retaining device, special tool 9662, on corresponding tension rod bolts and position with holder,
special tool P140.
Note
•
When tightening the tension rod bolts without a retaining device 9662, it is essential that a second
person braces the bolts.
•
The O−ring is damaged when the tension rod bolts are turned.
•
Use a 14 mm multiple−tooth socket from Snap−on to counter.
Retaining device 9662
34. Tighten tension rod bolts or studs with 50 Nm (37 ftlb.). When doing so, observe the tightening sequence.
Assembling the crankcase.
einordnung
408