Porsche 996 TT Repair Manual page 644

5. Screw on the turbocharger support. Do not forget the washer beneath the new hexagon nut when doing
this. Tighten the hexagon nut to 23 Nm (17 ftlb.). Then position the hexagon nut of the vent line by hand
and tighten to 20 Nm (15 ftlb.).
6. Install heat shield. Move heat shield into installation position again and tighten the two sheetmetal
nuts.
7. Push the pressure pipe back onto the turbocharger and tighten the hose clamp.
8. Install charge air cooler. Insert the charge air cooler in the studs on the body. Tighten the rear fastening
nut and the two fastening screws to 23 Nm (17 ftlb.).
9. Tighten the front fastening nut and the fastening screw to 23 Nm (17 ftlb.).
Installing turbocharger
einordnung
581