Porsche 996 TT Repair Manual page 460

1. Position the toothed segment special tool P201b on the stud and undo the pan−head screws of the
clutch pressure plate in several stages and in diametrically opposite sequence, to avoid deforming
the thrust plate.
2. Fasten mounting device P238b with holder P140 onto the studs. Loosen flywheel screws and remove
the flywheel. Make sure that the pulse sender is not damaged.
Note
• If the engine holder special tool (adapter ring) 9667 is used for the first time, 2 threaded bores must be
made in addition.
3. Mount engine holder. See also sub−section "Adapting engine holder". => Adapting engine holder
Note
• The pulse sender should not be detached!
• Shear bolts were installed in the first vehicles.
Shear bolts on pulse sender
4. The shear bolts are replaced by micro−encapsulated hexagon head bolts
Disassembling the crankcase
einordnung
397