Installing Oil Cooler - Porsche 996 TT Repair Manual

4. Pull coolant hose −2− off the oil cooler −1− . To do so, unscrew the screw−type hose clamp from
the coolant hose −2− and pull off the coolant hose.
5. Unscrew the four M6 screws −arrows− on the oil cooler and remove the oil cooler.
6. Suck out remaining oil.
top of page

Installing oil cooler

Note
• Always replace the O−rings for the oil cooler!
1. Replace seals. Replace the four O−rings −arrows− between the bracket and oil cooler. Coat the O−rings
with a small amount of universal grease and insert.
2. Place oil cooler in position with the four M6 screws and tighten.
Tightening torque of M6 screws = 10 Nm (7.5 ftlb.)
Removing oil cooler
einordnung
511