30 27 19 Removing and installing clutch pressure
hose − Engine installed
Caution
Removing clutch pressure hose
Installing clutch pressure hose
WARNING
Danger of injury if the clutch pressure hose is undone or disconnected without pressure reduction beforehand!
Reduce the pressure in the clutch system by actuating the clutch pedal at least 25 times!
Note
•
Take care when handling Pentosin! Wear protective glasses, gloves and protective clothing!
•
Protect any coolant hoses present near to the removal work from all emerging Pentosin using suitable
means!
•
If coolant hoses come into contact with Pentosin, thoroughly clean them with water immediately!
top of page
Removing clutch pressure hose
Requirements:
•
Raise vehicle on lifting platform.
•
Actuate the clutch pedal at least 25 times with the engine switched off so that the system is
depressurised.
1. Unclip the plug−in coupling for the hydraulic clutch operation system at the body (green line) and
unscrew using two open−ended wrenches a/f 15 −arrows A and B− .
2. Collect and dispose of emerging Pentosin by suitable means. Seal the green line with suitable rubber
or plastic plugs.
30 27 19 Removing and installing clutch pressure hose − Engine installed
668