Note
•
Camshaft adjusting element must be positioned to the left−hand stop! Use special tool holding wrench
9653 !
5. Turn camshaft adjusting element of the inlet camshafts to its left stop. Use special tool holding wrench
9653 to turn the actuating element of the inlet camshaft counter−clockwise until it meets the stop.
Note
•
Tighten the screws for the adjustment device only slightly. It must be possible to move the frame
easily by hand.
6. Fit adjustment devices. Use two screws to fasten the frame of both staking tools at the end of the
cylinder bank (clutch side) on the sealing surface for the valve cover. Tighten screws by hand only.
7. Insert holding keys. Insert the holding keys 9661/1 into the frame according to their identification
and then fasten them with two fastening screws to prevent them from dropping.
Adjustment device of cylinder bank 1 − 3
Setting the camshafts (timing)
einordnung
470