M6 x 20.
Hexagon head bolts on pulse sender
5. Loosen belt pulley. To do this, a second person should counter with the holding wrench 9548 at the same
time. Do not continue to use the hexagon−head bolt.
6. Loosen the 18 hexagon nuts (M8) of the housing screw connections.
7. Loosen the hexagon nuts (wrench size 17) in the left crankcase half (cylinder bank 1 − 3).
8. Loosen tension rod bolts from the outside to the inside.
Note
•
The tension rod bolts in thrust blocks 2, 3, 4 and 5 −arrows− can only be removed after removing the
crankcase half (cylinder bank 1 − 3).
Disassembling the crankcase
einordnung
398