Porsche 996 TT Repair Manual page 556

Reinstall the shield of the exhaust system. Tighten the two fastening nuts on the side member for this
purpose.
7. Install charge air cooler. To do so, place the charge air cooler back in the vehicle.
8. Tighten the front two fastening nuts and the fastening screw in the wheel well, all to 23 Nm (17 ftlb.).
9. Tighten the front fastening nut and the fastening screw to 23 Nm (17 ftlb.). Supply the two hose
connections on the charge air cooler with new O−rings and fit them in place. The connections must
audibly engage.
10. Tighten the two sheetmetal nuts on the heat shield.
Fit rear spoiler again ' 63 Removing and installing rear spoiler.
Location
Heat shield on camshaft cover
Plug coils
Fastening screws on the switch−over valve
Fastening screws on the charge air cooler
Fastening nuts on the charge air cooler
996420, 996421, 996450, 996451, 996620, 996621, 996650, 996651, 996840, 996841
Installing the hydraulic valve
einordnung
Thread Tightening torque Nm (ftlb.)
M6
M6 x 25
M6 x 25
M8
M8
10 (7.5)
10 (7.5)
10 (7.5)
23 (17)
23 (17)
493