7. Disconnect the connector at the throttle potentiometer −top arrow− and unscrew the four M6 screws
−arrows− .
8. Remove the throttle body.
top of page
Installing throttle body
Note
•
Always replace the seal between the intake distributor and the throttle body!
1. Insert seal into the intake distributor.
2. Position the throttle body on the intake distributor and position and tighten the four M6 screws
−arrows− .
Tightening torque of M6 screws = 10 Nm (7.5 ftlb.)
3. Position the Y−shaped pressure pipe with the rubber air cowl on the throttle body, connect the vacuum
hose −3− and fasten the spring band clamp. Connect the connector of the pressure sensor −4− and position
and tighten the M6 screws −1 and 2− .
Tightening torque of M6 screws = 10 Nm (7.5 ftlb.)
4. Install the holder over the air−conditioning compressor. Position and tighten the M6 screw in the
holder for this purpose.
Tightening torque of M6 screw = 10 Nm (7.5 ftlb.)
Removing throttle body
einordnung
618