Porsche 996 TT Repair Manual page 668

6. Position bracket on the crankcase and simultaneously use a screwdriver to connect the oil pump
drive shaft and the intermediate shaft. Do not use excessive force; gently press in place by hand.
7. Provisionally fasten the bracket using an auxiliary screw. The auxiliary screw can be removed again once
the oil lines and coolant hoses have been fastened.
Note
• Otherwise, the bracket is held only by the O−rings.
8. Apply Loctite 574 on the thread of the plug and fasten the plug.
Tightening torque 4 Nm (3.0 ftlb.).
9. Fit oil lines for the right−hand side. Use new O−rings.
Installation
einordnung
605