Tightening Torques - Porsche 996 TT Repair Manual

2. Clip in cable plug for hall sender using both
hands.
3. Fit the shields above the plug coils. Screw in the two hexagon−head bolts for this purpose.
Tightening torque: 10 Nm (7.5 ftlb.)
WARNING
Danger of fire! The heat shield should not be bent or deformed. Bent or deformed heat shields must be
replaced!
4. Install heat shield. See partial description in chapter ' 635019 Removing and installing rear bumper.
Sheetmetal nuts on heat shield
5. Install charge air cooler. => Removing and installing the charge air cooler
6. Install rear spoiler. ' 635519 Removing and installing rear
spoiler
top of page

Tightening torques

Location
Hall sender bolts
Heat shield ignition coils
996420, 996421, 996450, 996451, 996620, 996621, 996650, 996651, 996840, 996841
Installing hall sender
einordnung
Thread
M6
M6
Tightening torque [Nm] (ftlb.)
Replace; 10 (7.5)
10 (7.5)
655