order to avoid paint damage.
•
During emergency release, the spoiler must be held tightly by an assistant.
No. Procedure
1
Extend spoiler −1−
(with drive module
intact)
2
Lift up spoiler −1− (if
drive module is faulty)
3
Position outer tubes of
the extension elements
4
Unlock right extension
element
5
Unlock left extension
element
Remove spoiler −1−
top of page
Installing rear spoiler
Installing rear spoiler
einordnung
Instructions
Extend spoiler manually using the rocker switch with the ignition
switched on.
Pull spoiler upwards and push in two support pads −2− approx. 60 mm
high on the right and left between the rear lid and the spoiler. Note:
use suitable packaging material (e.g. styropore pad, cardboard) as a
support pad. The support pads should only be pushed in to the positions
shown in the figure.
Align the bore on the outer tube of the extension element −arrow− with
the bore of the closure peg −4− by turning the outer tube −3− .
The outer tube should be turned in an anti−clockwise direction only.
Insert hook wrench ' No. 80/1, 2.4 Workshop Manual into the bores and
turn clockwise by 90°.
Insert hook wrench ' No. 80/1, 2.4 Workshop Manual into the bores and
turn clockwise by 90°.
Lift the spoiler up and off.
979