75 19 Removing And Installing Sensor For Parkassistent; Removing Sensor For Parkassistent; Installing Sensor For Parkassistent - Porsche 996 TT Repair Manual

91 75 19 Removing and installing sensor for
ParkAssistent
Note

Removing sensor for ParkAssistent

Installing sensor for ParkAssistent

ParkAssistent control module
Note
Four sensors for the ParkAssistent are installed in the rear spoiler!
•
• The rear spoiler must be taken off in order to remove a defective sensor!
• When painting, make sure that not only the membrane but also the cylindrical membrane edge (2 mm)
is coated with paint!
Layer thickness: max. 120 µm
top of page
Removing sensor for ParkAssistent
1. Take off rear spoiler.
2. Pull off electrical plug connection.
3. Slightly bend up the holding peg on the sensor housing and push out the sensor.
4. Remove isolating ring from the sensor.
top of page
Installing sensor for ParkAssistent
Note
• Always fit the isolating ring before installing the sensor!
• The electrical plug connection in the vehicle must always point to the centre of the vehicle!
• Plug connection with marking (white adhesive tape) on the wiring harness always connected to outer
right sensor!

91 75 19 Removing and installing sensor for ParkAssistent

1107