Installation
1. Push coolant expansion tank into the guide rails and
fasten.
2. Attach connector from the sensor for the coolant−level
indicator.
3. Fasten the coolant hose with a new hose clamp 999.512.552.00 . Observe the installation position of the
screw−type hose clamp. The screw must be installed pointing vertically downwards.
4. Install intake
pipe:
Fix new seal onto the separation point/intake distributor.
•
•
Place suction line on the shaft bolts, at the same time push the hose of the recirculating air valves onto
the suction line.
•
Fasten the hexagon−head bolt.
•
Fasten ventilation line from the oil tank onto the intake distributor.
Installation
einordnung
527