Disassembly And Assembly Instructions; Disassembly - Porsche 996 TT Repair Manual

5 Spring plate
(compensation
part)
6 Coil spring
7 Stop plate
8 Cup washer
9 Additional spring 1
10 Protective bellows 1
11 Nut
12 Screw
13 Spring seat
14 Washer
15 Vibration damper 1
top of page

Disassembly and assembly instructions

Disassembly

CAUTION
Danger of injury due to spring tensioning!
• Never use an impact bolter to loosen or tighten the fastening nut!
• Use commercially available changeover ratchet!
Note
When installing new parts, observe the allocation according to the Spare Parts Catalogue!
•
To undo the connection − piston rod to spring strut mount − counter at the piston rod with countering
•
tool 9630 or a 7−mm Allen key.
Disassembly and assembly instructions
einordnung
1
1
1
1
1
1
1 Loosen spring seat from the
vibration damper only when
replacing it.
1 The washer is inserted in the
spring seat.
Observe allocation as per Spare
Parts Catalogue.
Observe allocation as per Spare
Parts Catalogue.
Mount in correct position (No. 7
and No. 2 are identical parts).
Mount in correct position.
Mount on protective bellows
(No. 10)
Tighten to 10 Nm (7.5 ftlb.).
The screw must be fitted in the
direction of travel.
Right and left side are different
(the cast number is stamped on
the bottom of the spring seat.) A
cast lug is located on the left
spring seat. The spring seat must
be centred on the vibration
damper.
Observe allocation as per Spare
Parts Catalogue.
341