Porsche 996 TT Repair Manual page 551

Snap ring
13 x 1.75
6 Bearing shell half
7 Thrust bearing shell half
8 Snap ring
36 x 1.75
9 Sprocket wheel
10 Woodruff key
6.0 x 7.5
11 Snap ring
36 x 1.75
12 Sprocket wheel
13 Woodruff key
14 Thread plug to drive
exhaust oil extraction
pump M18x1.5
15 Intermediate shaft
16 Timing gear
996420, 996421, 996450, 996451, 996620, 996621, 996650, 996651, 996840, 996841
15 20 37 Disassembling and assembling intermediate shaft
einordnung
Check, replace if
necessary
1
1
1 Check toothing for
wear, press off if
necessary
1
1
1 Check toothing for
wear, press off if
necessary
1
1 dispose of
1
1 Check teeth for wear Note reference number, paired with
Replace and insert into crankcase half of
cylinder bank 4−6
Replace and insert into crankcase half of
cylinder bank 4−6
The opening of the snap ring should lie
opposite the Woodruff key groove.
Warm on heating plate, push on up to stop.
Collar points towards intermediate shaft
gearwheel
The opening of the snap ring should lie
opposite the Woodruff key groove.
Warm on heating plate, push on up to stop.
Collar points towards intermediate shaft
gearwheel
Use Torx E10 tool,
replace screw,
tightening torque 25 Nm (19 ftlb.).
Paired with timing gear of the crankshaft,
only install together, take note of the
identification on the crankcase
intermediate shaft, only install together
488