3. Disconnect the clutch pressure hose −1− from the slave cylinder with an open ring or open−ended
wrench a/f 14 and remove the hose.
Note
•
Dispose of the old hose complete with the union nut and the holder!
top of page
Installing clutch pressure hose
Note
Make sure that the pressure hose is routed above the parking brake cable!
•
1. Position the clutch pressure hose −1− by hand on the slave cylinder and screw the hose tight with an open
ring or open−ended wrench a/f 14.
Tightening torque 30 Nm (22 ftlb.)
2. Remove the rubber or plastic plugs from the green pressure line on the underbody and screw in a new
plug−in coupling (complete with union nut, holder and assembly mandrel) by hand and then screw tight
with two open−ended wrenches a/f 15 −arrows A and B− .
Tightening torque 30 Nm (22 ftlb.)
Removing clutch pressure hose
einordnung
669