Porsche 996 TT Repair Manual page 288

4. Inserting cutting thread into the gap in the glass
g. Pull cutting thread −B− in the direction of the arrow through the gap between the glass and the
body. Use filler −A6− if necessary.
Note
• The cutting thread should be positioned under the rim as far as possible. The sealing lip must be
raised slightly in the upper part of the glass in order to pull the cutting thread through.
5. Attaching cutting thread to the body
h. Attach the loose end of the cutting thread −B− firmly at a suitable point on the body with the fastening
screw −2− of a component (e.g. wiper motor fastening). To do this, unscrew the fastening screw, wind
the cutting thread −B− around the screw and tighten the fastening screw again.
6. Attaching cutting
thread to the spooling
device
i. Undo clamping screw
−3− .
j. Insert cutting thread −B− into the bore on the spooling device −A3−
.
Removing glass with cutting wire separator
einordnung
225