39. Mount new cylindrical pin so that it is flush.
CAUTION
Danger of injury
•
The holding wrench must be in contact with the belt pulley when tightening.
40. Always replace fastening screw of the belt pulley. When tightening the belt pulley, a second person
must counter with the special tool 9548. The belt pulley is tightened to 170 Nm (126 ftlb.).
41. Fit flywheel.
42. Check distance −Dimension X− between toothed ring and pulse sender and adjust if necessary.
Dimension X 1.0 ± 0.2 mm
43. Turn belt pulley or the crankshaft to TDC, cylinder 1 or 4.
44. Subsequently fit piston or cylinder (see Serv. No.: 13 10 19)
996420, 996421, 996450, 996451, 996620, 996621, 996650, 996651, 996840, 996841
Assembling the crankcase.
einordnung
410