Table of Contents
Advertisement
Safety instructions for fuel tank
CAUTION
Danger of fire due to fuel tank or fuel−carrying parts heating up during grinding and welding work!
•
When carrying out grinding and welding work near the fuel tank or fuel−carrying parts, make sure
that these parts do not heat up!
•
It is recommended to remove endangered parts!
Cover the welding area comprehensively with fire−proof covers!
•
Safety instructions for air conditioning
CAUTION
Danger of injury due to the filled air−conditioning system bursting during welding and soldering work!
•
In the case of extreme heating of filled air−conditioning systems, a very strong overpressure may be
caused in the system which may lead to an explosion.
•
No welding, soldering or hot−air heating may take place on parts of the filled air−conditioning
system!
•
While drying after painting work, the temperature burden on the vehicle must not exceed two hours at
a maximum temperature of 80 °C!
•
Make sure that parts of the air−conditioning system do not heat up during welding or soldering work
on the vehicle!
top of page
Safety instructions for sticking
Safety instructions for Teromix−6700 two−component adhesive
CAUTION
Danger of damage to side section if binding time of adhesive is not observed!
•
The new part must be welded in within 30 minutes!
top of page
Safety instructions for fuel tank
einordnung
185
- Quick Links:
- Engine
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
