Avaya Media Processing Server 500 Hardware Installation And Maintenance page 93

Password: ******(access)
InReach:0 >enable
Password:******(system)
2. Run the show command to get the MAC address.
InReach:0 >>show port ethernet all char
Time: Fri, 02 Jan 1970 20:43:30 UTC
Name:
Link Speed:
Description:
Make a note of the MAC address (that is, 00:a0:9c:00:02:07). The last 6 digits are used to
make up the name of the configuration files.
3. Rename the configuration file lxperi.zip. Substitute the last 6 digits of the MAC address
determined in the previous step for the letters peri. For example, lx000207.zip.
4. Copy the lx------.zip file to lx------.prm, where ------ is the MAC address.
Performing the Initial Setup
Skip this step if you have already performed the setup.
1. Run the setup command at the InReach prompt.
2. Type y to run the Initial Connectivity Setup and follow the prompts as shown in the following
sample output.
InReach:0 >>setup
Would you like to run Initial Connectivity Setup? (y/n) : y
Enter the superuser password: ****** (system)
Quick Configuration Menu
1 Unit IP Address
2 Subnet Mask
3 Default Gateway
4 Domain Name Server
5 Domain Name Suffix
6 Superuser Password
7 Exit and Save
Enter your choice: 3
Default Gateway [A.B.C.D]: 10.7.200.100
Quick Configuration Menu
1 Unit IP Address
2 Subnet Mask
3 Default Gateway
4 Domain Name Server
5 Domain Name Suffix
6 Superuser Password
7 Exit and Save
Enter your choice: 7
CONFIGURATION SUMMARY
1 Unit IP Address
2 Subnet Mask
3 Default Gateway
4 Domain Name Server
5 Domain Name Suffix
6 Superuser Password
Is this information correct? (y/n) : y
Save this information to Flash memory? (y/n) : y
Saving to flash.............
October 2014
Configuring and Updating the Terminal Server through TFTP
eth0 MAC Address:
Auto Duplex Mode:
10.7.200.100
Avaya Media Processing Server 500 Hardware Installation and Maintenance
Comments? infodev@avaya.com
00:a0:9c:00:02:07
Auto
10.7.200.50
255.255.0.0
10.7.200.50
255.255.0.0
10.7.200.50
255.255.0.0
10.7.200.100
Not Changed
93