Login - Supermicro SSE-G24-TG4 User Manual

1/10 and 10-Gigabit Layer 2/3 Ethernet Switches User's Manual
The default management IP address for Supermicro Switch products is
192.168.100.102. This default IP address can be changed in the S
in the System Management section.
For the SSE-G48-TG4 and SSE-G24-TG4 switches you can connect to any of the front
panel 1G ports or back panel 10G ports to manage the switch with the default
management IP. These switches will create VLAN 1 by default with this IP address,
including all 1G and 10G ports.
For the SSE-X24S/R, SSE-X3348S/R or SSE-X3348T/R switches you can connect to
the 1G Ethernet RJ45 port, one of the 10G Ethernet ports, or one of the 40G Ethernet
ports (if so equipped); or the serial console port (on the front of the unit) to manage the
switch.
These switches will create VLAN 1 by default with this IP address - including all Ethernet
ports.
Note: Blade Switches can be managed with the default IP through the CMM Ethernet
connections. The internal management Ethernet ports of Blade Switches are connected
with the CMM Ethernet ports internally. If managing the Blade Switch through front panel
ports or any other switching ports is preferred, then the user can assign the desired
management IP address to VLAN 1. Alternatively users can create any VLAN and
manage the switch through switching ports. [Here the term switching ports refers to all
internal and external 1G and 10G ports of the switch.]
5-2

Login

Type the switch IP address in the browser. The following Login page appears.
The initial login page
management utility for 10 Gb/s switches. To login, enter your User Name and
Password in the fields provided and press the L
Figure 5-1. Login Page
(Figure 5-1) is used to login to the Supermicro Switch web-based
5-2
YSTEM
button.
OGIN
S page
ETTINGS