Ospf V3 - Supermicro SSE-G24-TG4 User Manual

1/10 and 10-Gigabit Layer 2/3 Ethernet Switches User's Manual
Table 5-102. OSPF As External Aggregation Configuration Page Parameters
Parameter
Aggregation Effect
Translation
Advertise

OSPF V3

The OSPFv3 link allows you to configure the OSPFv3 protocol through the following
pages:
• Basic Settings
• Interface
• Area
• Ext Aggregation
Description
This parameter specifies the Aggreation option as one of the following:
• Advertise – When set to advertise and associated Area ID is 0.0.0.0, then
the aggregated Type-5 are generated. Otherwise if the associated Area ID
is x.x.x.x (other than 0.0.0.0), then the aggregated Type-7 is generated in
NSSA x.x.x.x for the specified range.
• Do Not Advertise – When set to doNotAdvertise (2) and associated Area
ID is 0.0.0.0, then the Type-5 is not generated for the specified range, while
aggregated Type-7 are generated in all attached NSSA. While if the
associated Area ID is x.x.x.x (other than 0.0.0.0), then the Type-7 are not
generated in NSSA x.x.x.x for the specified range.
• Allow All – When set to allowAll and associated Area ID is 0.0.0.0, then the
aggregated Type-5 are generated for the specified range. In addition
aggregated Type-7 are generated in all attached NSSA for the specified
range.
• Deny All – When set to denyAll neither Type-5 nor Type-7 will be generated
for the specified range.
This parameter enables or disables the translation.
This parameter displays the aggregation status of OSPF.
5-144