Route Aggr - Supermicro SSE-G24-TG4 User Manual

1/10 and 10-Gigabit Layer 2/3 Ethernet Switches User's Manual
Table 5-111. BGP Filter Configuration Page Parameters
Parameter
Filter ID
Remote AS
IP Address
IP Address Prefix
Length
Intermediate AS
Direction
Action
Status

Route Aggr

Figure 5-131. BGP Route Aggregation Configuration Page
Clicking the R
OUTE
page (Figure 5-131), which is used to aggregate and configure the routes advertised by
BGP. The parameters for this page are shown in
Description
This parameter specifies the filter index. The allowed value ranges between 1
and 10.
This parameter specifies the remote AS associated with the BGP peer from
which the router is being distributed. The allowed value ranges between 0 and
65535.
This parameter specifies the IP address for which the route is being learned.
This parameter specifies the prefix length to calculate the Subnet. The allowed
value ranges between 0 and 32.
This parameter represents the intermediate AS between the BGP peers.
This parameter indicates the direction of the packet.
With this parameter you can choose either to Allow (not to filter) or Deny (Filter)
for the above configuration set.
This parameter specifies the status of the entry.
A tab brings up the BGP R
GGR
A
OUTE GGREGATION
Table 5-112.
5-156
C
ONFIGURATION