Port Control - Supermicro SSE-G24-TG4 User Manual

1/10 and 10-Gigabit Layer 2/3 Ethernet Switches User's Manual

Port Control

Clicking the P
ORT
allows you to change port parameters for ports that you select by clicking on the check
box in front of them (or checking ALL to select all ports). The parameters for this page
are shown in Table
Parameter
Mode
Advert
Duplex
Speed
FlowControl Admin
Status
FlowControl Oper
Status
HOL-Block
Prevention
Figure 5-52. Port Control Page
C tab brings up the P
ONTROL
5-41.
Table 5-41. Port Control Page Parameters
Description
This parameter allows you to select either Auto or NoNego for your port mode.
For each selected port you may choose to click on a check box for 10h, 10f,
100h, 100f or 1000f Advert options.
This parameter allows you to select either Half or Full options for Duplex if you
have already selected NoNegro for the Mode option. This option is unavailable if
the Auto mode option was selected.
This parameter allows you to select either 1 Gbps, 10 Mbps or 100 Mbps options
for port speed if you have already selected NoNegro for the Mode option. This
option is unavailable if the Auto mode option was selected.
This parameter allows you to select either Disabled, Transmit, Receive or Both
options for Flow Control Admin Status.
This parameter only provides information on what the Flow Control Oper Status
is and is not configurable on this page.
This parameter allows you to select either Enabled or Disabled options for
HOL-Block Prevention for the port.
C
ORT ONTROL
5-68
page (Figure 5-52), which