Rip - Supermicro SSE-G24-TG4 User Manual

1/10 and 10-Gigabit Layer 2/3 Ethernet Switches User's Manual

RIP

Clicking the RIP tab brings up the RRD RIP C
allows you to re-distribute the routes that are learnt through other routing protocols to
RIP. The parameters for this page are shown in
Table 5-117. RRD RIP Configuration Page Parameters
Parameter
RIP Status
Default Metric
Import
Route Tag Type
Route Tag
Figure 5-136. RRD RIP Configuration Page
Description
This parameter enables or disables redistribution for RIP.
This parameter specifies the metric for the routes that are being re-distributed.
The default value is 3.
You can use this parameter to choose to import Direct routes, Static routes,
OSPF routes and BGP routes to RIP.
This parameter describes whether a tag is manually configured or automatically
generated.
This parameter indicates the route tag in case you configure a manual option for
the tag type. The possible values are between 0 to 65535. The default value is 0.
ONFIGURATION
Table 5-117.
5-162
page (Figure 5-136), which