Policymap - Supermicro SSE-G24-TG4 User Manual

1/10 and 10-Gigabit Layer 2/3 Ethernet Switches User's Manual

Policymap

Clicking the P
OLICYMAP
which is used to specify action for a specified classmap. The parameters for this page
are shown in Table
Table 5-30. QOS Policymap Settings Page Parameters
Parameter
Policy Map ID
Class Map ID
Traffic Rate
In-Profile Action
Out-Profile Action
In-Profile Action
Value
Out-Profile Action
Value
Figure 5-37. QOS Policymap Settings Page
tab brings up the QOS P
5-30.
Description
This parameter specifies the unique ID for Policymap. The value ranges between
1 and 65535.
This parameter specifies the C
This parameter specifies the T
value ranges between 1 and 65535.
This parameter specifies the action to be applied on matched data, and can be
specified as either Policy DSCP or Policy Precedence.
This parameter specifies the action to be applied on out-of-profile data, and can
be specified as either Policy DSCP or Drop.
The I -P A
N ROFILE CTION
63 for IP Precedence.
The O -P A
UT ROFILE CTION
DSCP.
OLICYMAP
M ID to associate with Policymap.
LASS AP
R of data that has to be applied. The
RAFFIC ATE
V can be specified from 0 to 7 for DSCP, or from 0 to
ALUE
V can be specified as Drop or from 0 to 63 for
ALUE
5-50
S page (Figure
ETTINGS
5-37),