Table 5-32. VLAN COS Queue Scheduling and Bandwidth Control Page Parameters
Parameter
Reset to Defaults
Apply On Port Lists
Time Management
The Time Management link of the System page opens the Time Management page.
This page allows you to configure QoS through following pages:
•
NTP Settings
•
Clock Settings
NTP Settings
Clicking the NTP link brings up the NTP S
the Network Time Protocol (NTP). The parameters for this page are shown in
Table
5-33.
Parameter
NTP Client Settings
NTP Status
Description
Sets the default values for all the configuration in this page.
To apply the same configuration on multiple ports, provide the port list on this
field and click on A
PPLY
gi0/15, and so on.
Figure 5-40. NTP Settings Page
Table 5-33. NTP Settings Page Parameters
Description
This field enables or disables NTP in the switch, and allows you to configure the
NTP Servers section to enable NTP.
Chapter 5: Web Based Management Utility
. For example the port list should be like gi0/1-10, gi0/12,
page
(Figure
ETTINGS
5-53
5-40), which configures