LoopBack Settings
Clicking the L
OOP
(Figure
5-94), which allows you to configure loopback IP interfaces. The parameters for
this page are shown in
Table 5-76. LoopBack Basic Settings Page Parameters
Parameter
LoopBack Interface
Interface Type
Interface Status
IP Address
Subnet Mask
Figure 5-94. LoopBack Basic Settings Page
B
S
tab brings up the L
ACK
ETTINGS
Table
5-76.
Description
This parameter is the name of the loopback interface getting created.
This parameter is always the loopback for this configuration.
This parameter for the I
This parameter specifies the IP address for this loopback interface.
This parameter specifies the subnet mask for this loopback interface.
Chapter 5: Web Based Management Utility
B
OOP
S
can be set to Up or Down.
NTERFACE
TATUS
5-115
B
S
ACK
ASIC
ETTINGS
page