Tacacs+ Servers - Supermicro SSE-G24-TG4 User Manual

1/10 and 10-Gigabit Layer 2/3 Ethernet Switches User's Manual
Table 5-5. TACACS+ Global Settings Page Parameters
Parameter
Active Server IP
Address
Retries

TACACS+ Servers

Clicking the TACACS+ S
page (Figure 5-11), which allows you to configure TACACS servers. The parameters for
this page are shown in
Table 5-6. TACACS+ Server Configuration Page Parameters
Parameter
IP Address
Port
Single Connection
Description
Specifies the IP address of the active TACACS server. This server should have
been already configured in the TACACS+ S
(Figure 5-11). The factory default is 0.0.0.0.
This parameter determines the number of times the switch searches the active
TACACS server from the list of servers maintained. The allowed values are from
1 to 100. The factory default is 2.
Figure 5-11. TACACS+ Server Configuration Page
tab brings up the TACACS+ S
ERVERS
Table 5-6.
Description
This specifies the IP address of the TACACS server. The factory default is blank.
TCP port for TACACS protocol. The valid range is from
This specifies the
1 to 65000. The factory default is
Specify Yes or No for a single TCP connection. If Yes, it establishes only a single
TCP connection with a given TACACS server. The factory default is Yes.
ERVER
.
blank
5-20
C page
ONFIGURATION
C
ERVER ONFIGURATION