Interface - Supermicro SSE-G24-TG4 User Manual

1/10 and 10-Gigabit Layer 2/3 Ethernet Switches User's Manual
Table 5-103. OSPFv3 Basic Settings Page Parameters (Continued)
Parameter
SPF Hold Time
Default Passive

Interface

Trace Level
Interface
Clicking the I
NTERFACE
parameters for this page are shown in
Parameter
VLAN/Tunnel
Identifier
Area ID
Interface Type
Priority
Description
This parameter specifies the minimum time between two consecutive SPF
calculations. The allowed value ranges between 1 and 65535.The default value
is 10.
This parameter specifies whether all the OSPFv3 interfaces created after this
setting are passive or not.
This parameter defines the level of trace required for OSPFv3.
Figure 5-123. Interface Settings Page
tab brings up the I
Table 5-104. Interface Settings Page Parameters
Description
This parameter specifies the IPv6 interface over which OSPFv3 is enabled.
This parameter specifies the area ID associated with the IPv6 interface.
This parameter specifies the type of OSPFv3 interface (broadcast, nbma,
pointToPoint and pointToMultipoint).
This parameter specifies the priority of the interface. The allowed value ranges
between 0 and 255.The default value is 1.
S
NTERFACE ETTINGS
Table 5-104.
5-146
page (Figure 5-123). The