Storm Control/Rate Limiting - Supermicro SSE-G24-TG4 User Manual

Storm Control/Rate Limiting

Clicking the S
TORM
L page (Figure
IMITING
port. You can choose between Auto-negotiation and No-negotiation for a port. If
No-negotiation is chosen, then the speed of the link, FlowControl and duplex modes can
be configured. The parameters for this page are shown in
Table 5-42. Storm Control/Rate Limiting Page Parameters
Parameter
Port
Mode
Duplex
Speed
Flow Control Admin
Status
Flow Control
Operation Status
HOL Block
Prevention
The following parameters are configurable for Ingress Rate Limiting.
DLF Level
Broadcast Level
Figure 5-53. Storm Control/Rate Limiting Page
C /R L
ONTROL ATE
5-53), which allows you to configure specific parameters of the
Description
This parameter displays the port number.
This parameter allows you to select either Auto Negotiation or No-negotiation.
This parameter allows you to select either Full Duplex or Half Duplex.
This parameter allows you to select the speed as 10 Mbps, 100 Mbps or 1 Gb/s.
This parameter allows you to specify the Flow Control Admin Status as either
Disabled, Trasmit Flow Control Enabled, Receive Flow Control Enabled or both
Transmit and Receive Flow Control Enabled.
This parameter displays the status of the flow control.
This parameter allows you to enable or disable Head of Line block prevention.
This parameter allows you to specify the destination lookup failure packets per
second.
This parameter allows you to specify the broadcast packets per second.
Chapter 5: Web Based Management Utility
tab brings up the S
IMITING
5-69
C
TORM ONTROL
Table 5-42.
/R
ATE