Clock Settings; Stack - Supermicro SSE-G24-TG4 User Manual

Clock Settings

Clicking the C
LOCK
which allows to configure the Time and Date in the switch. The parameters for this page
are shown in Table
Parameter
Clock Display
Clock Set

Stack

The Supermicro Intelligent switch supports stacking of the SSE-G24-TG4 and
SSE-G48-TG4 Supermicro switch units. Switch stacking is created by connecting
switches in a daisy chain. One of the stacked switches is selected as a Master based on
its configurations. The Master switch provides management support for the whole stack.
Other switches in the stack are referred to as slave switches.
NOTE: Make sure all stacked switches are running the same version of firmware.
Figure 5-41. Clock Settings Page
S link brings up the C
ETTINGS
5-34.
Table 5-34. NTP Settings Page Parameters
Description
This display shows the time and date that the switch current has.
These controls allow you to set or modify the time and date. HH:MM:SS for the
Time, and DD:MM::YYYY for the date.
Chapter 5: Web Based Management Utility
S
LOCK ETTINGS
5-55
page (Figure 5-41),