Timer - Supermicro SSE-G24-TG4 User Manual

1/10 and 10-Gigabit Layer 2/3 Ethernet Switches User's Manual
Table 5-123. IGMP Snooping Configuration Page Parameters (Continued)
Parameter
Query Transmit On
TC
Multicast Filtering

Timer

Figure 5-146. IGMP Snooping Timer Configuration Page
Clicking the T
IMER
(Figure 5-146), which configures IGMP snooping timers. The parameters for this page
are shown in Table
Table 5-124. IGMP Snooping Timer Configuration Page Parameters
Parameter
Router Port
PurgeInterval (Secs)
Group-Member Port
Purge Interval (Secs)
Report Forward
Interval (Secs)
Group Query Interval
(Secs)
Description
This parameter allows you to enable or disable query transmit when topology
changes.
This parameter allows you to enable or disable the multicast filtering.
tab brings up the IGMP S
5-124.
Description
This parameter specifies the interval for which the learnt router port will be
purged. The default value is 125-seconds.
This parameter specifies the interval after which a port gets deleted, if IGMP
reports are not received on a port. The default value is 260-seconds.
This parameter specifies the interval within which the next report messages for
the same multicast group will not be forwarded. The default value is 5-seconds.
This parameter specifies the interval within which the switch sends a group
specific query on a port when an IGMPv2 leave message is received. The
default value is 2-seconds.
T
NOOPING IMER
5-172
C page
ONFIGURATION