1/10 and 10-Gigabit Layer 2/3 Ethernet Switches User's Manual
Table 5-95. OSPF Basic Settings Page Parameters (Continued)
Parameter
Default External
Route
Default External
Route Metric
Default External
Route Metric Type
External Link State
Database Limit
Area
Clicking the A
REA
The parameters for this page are shown in
Table 5-96. OSPF Area Configuration Page Parameters
Parameter
Area ID
Type
Description
This parameter allows you to Enable or Disable the Default External Route.
This parameter specifies the External Route Metric in range 0 to 16777215. The
default value is 10.
This parameter allows you to choose to configure the default route metric type as
"1" or "2".
This parameter specifies the maximum number of non-default AS-external-LSA
entries that can be stored in the link state database.
Figure 5-115. OSPF Area Configuration Page
tab brings up the OSPF A
Description
This parameter specifies the identifier for the area.
This parameter allows you to configure the area type, as a Stub area, a Normal
area or NSSA.
C
REA
ONFIGURATION
Table
5-96.
5-136
page
(Figure
5-115).