Component - Supermicro SSE-G24-TG4 User Manual

Table 5-133. PIM Basic Settings Page Parameters (Continued)
Parameter
Registration Stop
Rate Limiting Period
PMBR Status
Static RP

Component

Figure 5-157. PIM Component Configuration Page
Clicking the C
OMPONENT
(Figure 5-157). The parameters for this page are shown in
Table 5-134. PIM Component Configuration Page Parameters
Parameter
Component ID
Candidate CRP Hold
Time
Mode
Description
This parameter specifies the registration stop rate limiting period in seconds. It
should be between 0 and 2147483647. The default value is 5 seconds.
This parameter allows you to enable or disable the PMBR status in the switch.
This parameter allows you to enable or disable the Static RP in the switch.
tab brings up the PIM C
Description
This parameter specifies a number uniquely identifying the component. The
allowed value ranges between 1 and 255. The default value is 1.
This parameter specifies the hold time of the component when it is a candidate
RP in the local domain.
This parameter specifies the mode of the component. It can be Sparse or Dense.
Chapter 5: Web Based Management Utility
OMPONENT
5-183
C page
ONFIGURATION
Table 5-134.