Protected Ports - Supermicro SSE-G24-TG4 User Manual

1/10 and 10-Gigabit Layer 2/3 Ethernet Switches User's Manual
Table 5-42. Storm Control/Rate Limiting Page Parameters (Continued)
Parameter
Multicast Level
The following parameters are configurable for Egress Rate Limiting.
Egress Port Rate
Limit
Egress Port Burst
Size

Protected Ports

Clicking on the Protected Ports tab brings up the P
The P
ROTECTED
parameters. You can choose between non-protected or protected for a port. If you
choose a protected port, it can be a standalone or a single group member. The
parameters for this page are shown in
Parameter
Port
Port Mode
Group ID
Description
This parameter allows you to specify the multicast packets per second.
This parameter allows you to specify the egress limit of packets per second.
This parameter allows you to specify the egress limit of packet burst size.
Figure 5-54. Protected Ports Page
P page allows configuration of the port specific protected
ORTS
Table 5-43. Protected Ports Page Parameters
Description
Port number.
This helps to configure the mode as Normal or Protected port or Protected
Group.
Choose the group identifier. This is enabled only in the Protected Group mode. 0
means the standalone protected port.
ROTECTED
Table 5-43.
5-70
P page (Figure
ORTS
5-54).