Interface - Supermicro SSE-G24-TG4 User Manual

Interface

Clicking the I
NTERFACE
parameters for this page are shown in
Parameter
Interface
IP Address
Status
Split Horizon
Default Route
Installation
Send Version
Receive Version
Route Age Timer
Figure 5-108. RIP Interface Page
tab brings up the RIP I
Table 5-90. RIP Interface Page Parameters
Description
This parameter specifies the Interface ID for which RIP needs to be configured.
This parameter specifies the IP address of the RIP interface.
This parameter specifies the admin status of the interface.
This parameter specifies the operational status of Split Horizon in the system.
This parameter specifies whether Default Route Installation can be done or not.
This parameter allows selecting the RIP packets sent to be compatible to either
RIPV1, RIP1 Compatible or RIPv2.
This parameter is similar to S
packets to be received as either RIPV1, RIPV2, both RIPv1 and RIPv2 or None.
This parameter specifies the time interval after which the routes will be flushed.
The allowed value ranges between 30 and 500. The default value is 180.
Chapter 5: Web Based Management Utility
page
NTERFACE
Table 5-90.
V , but it allows you to choose the RIP
END ERSION
5-129
(Figure 5-108). The