Threshold - Supermicro SSE-G24-TG4 User Manual

1/10 and 10-Gigabit Layer 2/3 Ethernet Switches User's Manual
Table 5-136. Candidate RP Configuration Page Parameters
Parameter
Component ID
Group Address
Group Mask
RP Address

Threshold

Clicking the T
HRESHOLD
(Figure 5-160). The parameters for this page are shown in
Table 5-137. PIM Threshold Configuration Page Parameters
Parameter
Group Threshold
Source Threshold
Switching Period
Description
This parameter specifies a number uniquely identifying the component.
This parameter represents the multicast group, for which the switch advertises
itself as the candidate RP. This can be IPV4 or IPV6.
This parameter specifies the subnet mask, which when combined with the group
address gives the group prefix.
This parameter represents the IP address of the Candidate-RP.
Figure 5-160. PIM Threshold Configuration Page
tab brings up the PIM T
Description
This parameter is a bits-per-second (BPS) value that when it exceeds a certain
value, initiates source specific counters for a particular group.
This parameter is a bits-per-second (BPS) value that when exceeds a certain
value, initiates switching to shortest path tree.
This parameter specifies the time interval that the data rate is monitored for,
initiating the counters or for switching to SPT.
HRESHOLD
5-186
C page
ONFIGURATION
Table 5-137.