Virtual Interface - Supermicro SSE-G24-TG4 User Manual

Virtual Interface

Figure 5-117. OSPF Virtual Interface Configuration Page
Clicking the V
IRTUAL
C
ONFIGURATION
Table 5-98.
Table 5-98. OSPF Virtual Interface Configuration Page Parameters
Parameter
Transit Area ID
Neighbor Router ID
Authentication Type
MD5 Key ID
Authentication Key
Hello Interval
Route Dead Interval
I tab brings up the OSPF V
NTERFACE
page (Figure 5-117). The parameters for this page are shown in
Description
This parameter specifies the transit area that the virtual link traverses.
This parameter specifies the router ID of the virtual neighbor.
This parameter allows you to choose MD5, Simple Password or None as the
authentication type.
This parameter specifies the secret key used to create the message digest
appended to the OSPF packet if the authentication type is MD5.
This parameter specifies the key required for authentication, if authentication is
enabled on this interface.
This parameter indicates the length of time, in seconds, between the Hello
packets that the router sends on the interface. The allowed value ranges
between 1 and 65535. The default value is 10.
This parameter specifies the number of seconds for which the router waits for
hello packet from the neighbor before declaring this neighbor down. The allowed
value ranges between 0 and 2147483647. The default value is 60.
Chapter 5: Web Based Management Utility
IRTUAL
5-139
I
NTERFACE